Release History

Version 1.14 to 1.16

(1) Eliminated a potential latency problem.
(2) Enhanced the MIDI data stream for Switchblade users.
(3) Enabled the BegValu setting when XPDL type is set to SWITCH.

*** Re-calibrate the pedals/switches connected to the XPDL ports after installing v1.16

Early Firmware Limitation(s)

FX1 firmware versions earlier than v1.14 do not support the FX1 Editor commands for FILE > SEND DATA TO FX1 and FILE > GET DATA FROM FX1. Therefore, before using the FX1 Editor to upgrade your FX1's firmware to v1.14, we recommend that you initiate a SysEx Data Dump to the FX1 Editor from the FX1 as outlined in the FX1 User Manual in Section 16.7 - Data Dump/Load. Make sure the FX1 Editor is running before you initiate the SysEx Data Dump on the FX1 so that if you have everything connected properly and the FX1 Editor has its MIDI I/O configured properly, it will provide you with a progress bar as soon as it starts receiving the SysEx Data Dump from the FX1. Don't forget to do a FILE > SAVE AS of the data onto your hard-disk before upgrading the FX1 firmware.

End User License Agreement